Set Static Learning

Command Dictionary

 

 

Set Static Learning

Tools Supported: FastScan and FlexTest

Scope: Setup mode

Prerequisites: This command is only useful before FastScan or FlexTest flattens the design to the simulation model, which happens when you first attempt to exit Setup mode or when you issue the Flatten Model command.

Usage

SET STatic Learning {ON [-Limit integer]} OFf

Description

Specifies whether FastScan or FlexTest performs the learning analysis to make the ATPG process more efficient.

The Set Static Learning command controls whether FastScan or FlexTest performs the learning analysis immediately after design flattening. FastScan or FlexTest uses the learned behavior for intelligent decision making in later processes, such as ATPG and DRC.

If you use the Set Static Learning ON command, the additional learned behavior focuses primarily on bus gates. This command also allows the test pattern generation process to immediately recognize conflicts and restricted decisions on ATPG constraints that result from the gate assignments. By enabling static learning, you prevent FastScan or FlexTest from unneccessarily remaking many decisions, thereby improving the ATPG performance.

For more information about the learning analysis, refer to “ Learning Analysis” in the Scan and ATPG Process Guide.

Arguments

ON -Limit integer

A literal and an optional switch and integer pair that enables FastScan to perform additional static learning analysis. This is the default behavior upon invocation of FastScan or FlexTest.

2-586

FastScan and FlexTest Reference Manual, V8.6_4

Page 614
Image 614
Mentor v8.6_4 manual Set Static Learning