Command Dictionary | Analyze Fault |
|
|
1 — A literal that specifies that the tool analyze the | pin_pathname for a |
| |
∙ |
|
A switch and integer pair that specifies the observe point for the sensitization analysis.
gate_id# — An integer that specifies a gate identification number whose location you want to use as the observe point for the sensitization analysis.
∙-Time integer (FlexTest Only)
A switch and integer that specifies the pin strobe time for the sensitization analysis. Pin strobes always occur at the end of a timeframe, and the time value of a pin strobe is always the timeframe number+1.
∙-Boundary (FastScan Only)
A switch that specifies to display the boundary faults when analyzing an ATPG untestable, tied, blocked, or redundant fault.
∙-Auto (FastScan Only)
A switch that automatically determines how far along the path FastScan can successfully propagate a transition of a path delay fault.
∙
A switch that forces the tool to complete the analysis of faults which have already been detected by the pattern set. This allows you to inspect the generated pattern by using the Report Faults command.
If you do not specify this switch and FastScan detects the fault category by simulation, by implication, or as unused, then FastScan displays a message and terminates the analysis.
∙-Display (FastScan Only)
A switch that specifies for FastScan to create a gate list relevant to the faults generated and, if DFTInsight is invoked, to automatically update the schematic view with the information.
FastScan and FlexTest Reference Manual, V8.6_4 |
