Command Dictionary

Delete Paths

 

 

Delete Paths

Tools Supported: FastScan

Scope: Atpg, Good, and Fault modes

Prerequisites: You must add path definitions with the Load Paths command and then faults to those paths with the Add Faults or Load Faults commands before you can delete path delay faults.

Usage

DELete PAths {path_name... -All -False_paths}

Description

Removes the specified path delay faults from the current fault list.

The Delete Paths command removes path delay faults specified with the Load Paths command. When you specify for FastScan to remove a path delay fault from the current fault list, FastScan also removes the patterns for that fault from the internal pattern set.

Arguments

path_name

A repeatable string that specifies the name of an existing path that resides in the current path definition file and whose path delay faults you want to remove from the current path delay fault list.

-All

A switch that removes all path delay faults from the current fault list.

-False_paths

A switch that causes an ATPG analysis to be performed for each path, and those proved false are deleted.

This ATPG process may be very lengthy. A progress message is displayed after every 100 paths analyzed, as well as at the end of

Note the analysis.

FastScan and FlexTest Reference Manual, V8.6_4

2-197

Page 225
Image 225
Mentor v8.6_4 manual Delete Paths, ∙ -Falsepaths