Command Dictionary | Delete Observe Points |
|
|
Delete Observe Points
Tools Supported: FastScan
Scope: Atpg, Fault, and Good modes
Prerequisites: You must add observe points with the Add Observe Points command before you can delete them.
Usage
DELete OBserve Points pin_pathname...
Description
Removes observe points from the specified pins.
The Delete Observe Points command deletes observe points added using the Add Observe Points command.
When you issue this command, the tool discards the current fault list. You must recreate the fault list to perform additional fault simulation.
You use this command primarily for simulating
Arguments
∙pin_pathname
A repeatable string that specifies a list of pins from which you want to delete observe points.
∙-All
A switch that deletes all observe points.
Examples
The following example deletes an incorrect observe point:
set system mode fault
add observe points i_1006/o add observe points i_1007/o delete observe points i_1006/o
FastScan and FlexTest Reference Manual, V8.6_4 |