HP M407 manual Message Possible cause Solution Blinking, Use Focus Lock see, Camera shake

Message	Possible cause	Solution
Blinking	The focus	Set the camera to
	distance is closer	Macro	shooting mode
	than the camera	or move farther away.
	can focus without
	being in the
	Macro
	shooting mode.
UNABLE TO	The camera	z Use Focus Lock (see
FOCUS and	cannot find focus	page 34). Point at a part
blinking	in the Macro	of the scene that is
	shooting mode,	brighter.
		z Make sure the camera is
	possibly due to
	low contrast.	within Macro range (see
		page 38).
	The light is low	Use the flash (see Setting
	and the image is	the Flash on page 37), or
(camera shake	likely to be blurry	use a tripod.
	due to the long
warning)
	exposure
	required.
ERROR SAVING	The optional	z Always wait until the
IMAGE	memory card that	Memory light stops
or	is installed was	blinking before removing
ERROR SAVING	removed before	the memory card from
VIDEO	the camera	the camera.
	finished writing to	z With the camera turned
	the card or was	off, remove the memory
	half-locked.	card and check to see if
		the locking tab on the
		edge of the card is fully
		in the unlocked position.

114 HP Photosmart M407 User’s Manual