Accessories Installation

Memory

Memory

This section provides step-by-step instructions for installing RAM cards in your Model 743.

Preliminary Requirements

Perform the following steps before you install a RAM card in your Model 743:

1If the Model 743 is already installed in your system card cage, you must remove it. See Chapter 3 of this book for instructions on removing and re- placing the Model 743.

2Place the Model 743 on a static free mat on a clean, level surface.

RAM Card Installation

You do not need to follow any particular card order when installing RAM cards into your Model 743. Use these steps to install the RAM cards:

1Place the first RAM card on the board standoffs, lining up the connector on the RAM card with the connector on the board, as shown in Figure 2-1.

2Gently press to seat the RAM card in the connector.

3To stack RAM cards, install standoffs between each card, ending with re- taining screws on the top RAM card. If you install single RAM cards in either the left or right locations, the retaining screws go into the board standoffs.

2-5