Accessories Installation

PMC Bridge Adapter and Expansion Adapter

O-Ring Gasket

PMC Card

Bezel blank

Site 2

Site 1

Bridge Adapter

Figure 2-6

Installing a PMC Card onto the Bridge Adapter

If you are installing only the bridge adapter, go on to step 11. If you are also installing the expansion adapter, continue with step 4.

4Refer to your PMC card installation manual, and set any configuration switches or jumpers that may be required for your application.

5On the PMC expansion adapter, remove the bezel blank(s) from the sites where you will be installing the PMC card(s). See Figure 2-7.

NOTE:When installing a PMC card, ensure that the O-ring type gasket near the bezel remains in place.

6Install PMC card(s) onto the expansion adapter by aligning the front of the card with the front bezel, and the rear of the card with the connectors and

2-15