Accessories Installation

PMC Bridge Adapter and Expansion Adapter

9Making sure that the connector and bezels are properly aligned, install the PMC expansion adapter onto the bridge adapter, as shown in Figure 2-9.Ensure that the interboard connector seats properly by applying pressure to the top of the expansion board and to the bottom of the bridge board.

There are two screws that secure the front bezel and four screws to secure the VMEbus connectors.

NOTE:If the interboard connector is not tightly seated, PMC cards on the expansion adapter will not operate.

Expansion Adapter

Connector Screws (4)

with 2 PMC Cards Installed

 

Interboard

Connector

Front Bezel Screws (2)

Bridge Adapter

Figure 2-9

Installing the Expansion Adapter onto the Bridge Adapter

2-18