CLI commands

active

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl

active

Enable this VAP (VSC).

no active

Disable this VAP (VSC).

beacon dtim count

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl

beacon dtim count <number>

Defines the DTIM period in the beacon.

Client stations use the DTIM to wake up from low-power mode to receive multicast traffic. The service controller transmits a beacon every 100 ms. The DTIM counts down with each beacon that is sent, therefore if the DTIM is set to 5, then client stations in low-power mode will wake up every 500 ms (.5 second) to receive multicast traffic.

beacon transmit power

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl

beacon transmit power

Advertise the current transmit power setting in the beacon.

no beacon transmit power

Do not advertise the current transmit power setting in the beacon.

data rate

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl

data rate (a b g bg n) <rate>

Enable the given data rate for a particular PHY type.

no data rate (a b g bg n) <rate>

Disable the given data rate for a particular PHY type.

public forwarding

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl

public forwarding (any 802.1x none ipv6)

Enables support for traffic exchange between wireless client stations.

access lan stations

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl

access lan stations

Permits traffic exchange between wireless and LAN stations.

2-97