CLI commands

bandwidth control internet-port normal

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl

bandwidth control internet-port normal <min-tx-%><min-rx-%><max-tx-%> <max­ rx-%>

Sets the bandwidth rates (Tx minimum, Tx maximum, Rx minimum, and Rx maximum) for traffic classed as Normal.

bandwidth control internet-port very-high

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl

bandwidth control internet-port very-high <min-tx-%><min-rx-%><max-tx-%><max-rx-%>

Sets the bandwidth rates (Tx minimum, Tx maximum, Rx minimum, and Rx maximum) for traffic classed as Very High.

ip route gateway

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl

ip route gateway<destination>/<mask> <gateway> <[metric]>

Adds a static route.

no ip route gateway <destination>/<mask> <gateway> <[metric]>

Removes the specified static route.

Parameters

<destination>

Traffic addressed to this IP address will be routed.

<mask>

Indicates the number of bits in the destination address that is checked for a

 

match.

<gateway>

Indicates the IP address of the gateway the service controller will forward

 

routed traffic to. The gateway address must be on the same subnet as one

 

of the available interfaces (Internet port or LAN port).

<metrix>

Indicates the priority of a route. If two routes exist for a destination

 

address then the service controller chooses the one with the lower metric.

firewall mode

Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl

firewall mode (highlownone)

Sets the firewall mode.

Parameters

high

Permits all outgoing traffic. Blocks all externally initiated connections.

low

Permits all incoming and outgoing traffic, except for NetBIOS traffic. Use

 

this option if you require active FTP sessions.

none

Disables the firewall.

2-41