CLI commands
switch port
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
switch port <name>
Switch to the ethernet port context.
syslog
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
syslog
Switch to syslog context.
sensor server name
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
sensor server name <name>
Sets the IP address or hostname of the the RF Manager Server to connect to.
Parameters
Name | Specify the IP address of the the RF Manager Server or its hostname. If a |
| hostname is specified, the service controller must be able to resolve it via |
| DNS, that is, an entry must be created on the network DNS server that |
| points to the IP address of the RF Manager Server. |
sensor server id
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
sensor server id <id>
Sets the server ID of the the RF Manager Server to connect to.
Parameters
ID | Specify the Server ID of the RF Manager Server to connect to. Set the |
| Server ID to 0 to have the service controller send a discovery request to all |
| active RF Manager Servers. The service controller will connect to the first |
| server that responds to the discovery request. |
sensor discovery mode
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
sensor discovery mode (id ip)
Sets the method the service controller will use to communicate with the RF Manager Server.
Parameters
id | Connect using the Server ID of the RF Manager Server. |
ip | Connect using the IP address or hostname of the RF Manager Server. |
Description
For these methods to work, the following must be true:
The service controller must be able to reach the RF Manager Server via a network connected to port 1 or port 2. For example, you should be able to ping the RF Manager Server IP address from the service controller.