Setup Menus

Wyse Settings

This dialog box is displayed by selecting Wyse in the Settings menu. Note that some of the settings apply to the TVI 910+, TVI 920, TVI 925, ADDS A2 and HZ 1500 emulations in addition to the Wyse emulations. Also, some settings may not apply to the particular Wyse emulation currently running. Selecting a setting that is not applicable to the current emulation will cause the emulator to use the default setting for that emulation when the dialog box is exited.

Note: The Tab Stops dialog box displayed by clicking the Set Tabs button is described later in this chapter, after the Terminal Settings description.

Lines

Factory default: 24

This option applies to the WY-50+ and WY-60 emulations and specifies the number of data lines displayed on the screen below the status line. Note that the other emulations only support 24 lines and a label line.

2424 data lines and a label line at the bottom.

2525 data lines but no label line.

4242 data lines and a label line at the bottom.

4343 data lines but no label line.

6-43