Setup Menus

New Connection...

(Not available in WBT mode)

Factory default: Serial, Com 1

This will display a dialog box that enables you to make a host connection.

The Type list box specifies the type of host connection that is to be made.

The Connect To box specifies the port or host to communicate with. You can either make a selection from the list or enter a valid host name or internet address.

The host connection will be closed if you change the settings in the New Connection dialog box and attempt to connect, if you log out of the host, or the host closes the connection. Warning messages will be displayed if the host closes the connection, or you attempt to open a new session or exit the emulator while a session is open.

Making A Serial Host Connection

To connect to a serial host, select Serial in the Type list box (default), then select the Com port required in the Connect To list box. Click the Configure... button to display the Serial Settings dialog box and make sure the settings match that of the host. Click OK then Connect.

Note: These options are described in the Serial Settings section later in this chapter and only apply when the connection type is set to Serial.

6-10