Setup Menus

Selecting End on Non-Hexenables you to specify the number of characters that make up the end sequence in the End Length box. The bypass will then terminate as soon as a non-hexadecimal character is received (any character except in the range 0 through 9 and A through F) followed by the end sequence.

Characters can be entered in several ways. For example, to specify the ASCII escape character, you can enter either _027, \u001B, \e, \033, or even ^[.

Font

This enables you to specify the font to be used for displaying characters. The available settings depend on the fonts installed.

Telnet Options

Clicking the Telnet Options button will display a dialog box with additional options. These are described in the Getting Started chapter.

National Character Settings & APL2

This enables you to select the character set to be used. The IDs of the code page, character set and CCSID used for the currently selected language are displayed under the User Specified button. Clicking User Specified will display a dialog box that enables you to change these settings.

There are separate Code Page, Character Set and CCSID entries for the Single Byte Character Set (SBCS) and, if supported, Double Byte Character Set (DBCS). These should only be changed by the System Administrator. If they have been changed and you wish to restore the default settings, click the Default button in the IBM 3270 Settings dialog box. The following table shows the default settings.

6-52