Setup Menus

Auto Page

Factory default: Unselected

This option applies to the WY-50+, WY-60 and all the TVI emulations. It determines what happens when the cursor reaches the top or bottom of the page.

When unselected, the cursor either moves to the top of the same page or data scrolls up from the bottom, as determined by the setting of the Auto Scroll option. When selected, a new page of memory will be displayed.

Note: The other emulations will always display a new page of memory.

Auto Wrap

Factory default: Selected

The setting of this option determines whether characters wrap to the next line when the right margin is reached. When unselected, on reaching the right margin, the last character position will be overwritten by every new character received.

DEL = DestBS

Factory default: Unselected

This option applies to the WY-50+ and WY-60 emulations and determines what effect an ASCII DEL character has on displayed characters. The other emulations ignore the DEL character.

When unselected, the DEL character is ignored. When selected, the DEL character is interpreted as a destructive backspace, causing the character to the left of the cursor to be deleted and the cursor to move into that position.

Margin Bell

Factory default: Unselected

This option applies to all emulations and specifies whether or not an audible warning sounds when the cursor reaches a specified column. The default bell column number is 72 in 80 column mode and 124 in 132 column mode.

Enhance

Factory default: Selected

When this option is selected, the emulator will recognize an additional set of Wyse codes which are not normally supported by specific non-Wyse terminals.

Answerback Mode

Factory default: Unselected

This option applies to all emulations and specifies whether or not an answerback message is automatically sent to the host in response to an ASCII ENQ character.

6-46