HP Sander 16500C manual LOADCONFig, CommandMMEMoryLOADCONfig name,msus,module, 12-15

MMEMory Subsystem

LOAD[:CONFig]

LOAD[:CONFig]

Command:MMEMory:LOAD[:CONfig] <name>[,<msus>][,<module>]

The LOAD command loads a configuration file from the disk into the modules, software options, or the system. The <name> parameter specifies the filename from the disk. The optional <module> parameter specifies which module(s) to load the file into. The accepted values are –2 through

10.Not specifying the <module> parameter is equivalent to performing a ’LOAD ALL’ from the front panel which loads the appropriate file for both the system and the modules, and any software option.

<name> A string of up to 10 alphanumeric characters for LIF in the following form:

NNNNNNNNNN

or

A string of up to 64 alphanumeric characters for DOS in one of the following forms:

NNNNNNNN.NNNwhen the file resides in the current directory or \NAME_DIR\FILENAME when it does not reside in the current directory

<msus> Mass Storage Unit specifier. INTernal0 for the hard disk drive and INTernal1 for the flexible disk drive.

<module> An integer, –2 through 5 for the HP 16500C alone. –2 through 10 with the HP 16501A connected.

ExampleOUTPUT XXX;":MMEMORY:LOAD:CONFIG ’FILE ’" OUTPUT XXX;":MMEMORY:LOAD ’FILE ’,0"

OUTPUT XXX;":MMEM:LOAD:CONFIG ’FILE A’,INTERNAL0,1"

12–15