HP StoreServ Application Suite for Oracle Media manual Startrcopygroup groupname

Recovery Manager for Oracle User’s Guide

where <target name> is the name of the remote target that has been created using

creatercopytarget.

NOTE: Ensure the target status is Ready.

6Verify the Remote Copy links.

cli% showrcopy links

NOTE: Ensure the link status is Up.

9.3.2.1 Starting and Synchronizing Remote Copy Groups

Before using Recovery Manager with Remote Copy, groups in both the primary/local and secondary/remote InServ Storage Servers should be started and in a synchronized state. Starting and synchronizing the groups can be achieved by executing the following CLI commands from the primary/local InServ Storage Server:

■startrcopygroup <group_name>

where <group_name> is the name of the Remote Copy group which contains all virtual volumes used by database datafiles and archive log destinations.

NOTE: The CLI command showrcopy can be used to check the synchronization status.

Prior to Recovery Manager release 3.0.0, two Remote Copy groups were required if archive log mode was enabled; one for datafiles and one for archive log destinations. If you wish to use one group configuration (recommended), where all datafiles and archive log destinations are within the same Remote Copy group, be sure to synchronize the Remote Copy group after you reorganize your Remote Copy group members. You can do this by issuing the

syncrcopy <group_name> command.

9.8

Verifying Remote Copy Settings