Installing And Configuring LDAP-UX Client Services

Configure the LDAP-UX Client Services

 

 

printer configurations on your client system. A new printer schema,

 

 

which is based on IETF<draft-fleming-ldap-printer-schema-02.txt>, is

 

 

required to start the services.

Step

7.

If the publickey schema has already extended, setup skips this step.

 

 

Otherwise, enter “yes” to extend the publickey schema if you choose to

 

 

store the public keys of users and hosts in the LDAP directory. A

 

 

publickey schema, which is based on RFC 2307-bis is required to migrate

 

 

the publickeys in the NIS+ credential table entries on the NIS+ server to

 

 

the LDAP directory.

Step

8.

If the new automount schema has already been imported, setup skips to

 

 

step 9.

Otherwise, you will be asked whether or not you want to install the new automount schema which is based on RFC 2307-bis. Enter “yes” if you want to import the new automount schema into the LDAP directory server. Enter “no” if you do not want to import new automount schema into the LDAP directory server. Setup skips to step 9 if you enter “no”.

Step 9. Next, if the setup program detects the obsolete automount schema exists in the LDAP directory, it will prompt you for the information shown as follows:

The obsolete automount schema exists in the directory.

If you still want to use the new automount schema, you must perform the following steps:

1.Exit this program

2.Stop directory server

3.Remove the obsolete automount schema:

a.objectclass- automount

b.attribute-automountInformation

Note: for Netscape Directory Server, they are in 10rfc2307.ldif.

4.Start directory and re-run setup program to install the new automount schema.

Do you still want to use the new automount schema? Press Yes will exit this program. {YES]:

Reply “yes ” when asked do you still want to use the new automount schema. If you reply yes, it will take you to exit this program. You must re-run the setup program again to install the new automount schema after you exit this program and manually delete the obsolete automount

30

Chapter 2