Installing the SFM Software
Verifying Removal of the SFM Software
|
| Verifying Removal of the SFM Software |
|
| This section describes how to use the TUI and the CLI to verify whether |
|
| the SFM software is removed successfully. |
|
| Verifying Removal Using the TUI |
|
| To verify whether the SFM software is removed successfully, complete |
|
| the following steps: |
Step | 1. | Log in to the system as a superuser. |
Step | 2. | Click Logfile in the Remove Window. |
|
| If there are no errors in the Logfile, the SFM software is removed |
|
| successfully. If the SFM software is not removed properly, you must |
|
| repeat the removal procedure. See “Removing the SFM Software” on |
|
| page 30 for instructions on how to remove the SFM software. |
Step | 3. | For information about errors related to the removal of SFM, enter the |
|
| following command at the |
|
| # swjob |
|
| The jobid is available in the Logfile. |
|
| Verifying Removal Using the CLI |
|
| To verify if the SFM software is removed successfully, complete the |
|
| following steps: |
Step | 1. | Log in to the system as a superuser. |
Step | 2. | Enter the following command at the |
|
| # swjob |
|
| If the output contains no errors, the SFM software is removed |
|
| successfully. If the SFM software is not removed properly, you must |
|
| repeat the removal procedure. See “Removing the SFM Software” on |
|
| page 30 for instructions on how to remove the SFM software. |
Step | 3. | For information about errors related to the removal of the SFM software, |
|
| enter the following command at the |
38 | Chapter 2 |