HP UX System Fault Management (SFM) Software 36

Installing the SFM Software

Removing the SFM Software

Step 7. When the SFM software is removed, the Remove Window is displayed, as shown in the following figure:

Step 8. To verify whether the SFM software is removed properly, enter the following command at the HP-UX prompt:

#swlist grep SysFaultMgmt

If the SFM software is removed properly, SysFaultMgmt and the version number of the SFM software does not appear in the output. If the SFM software is not removed properly, you must repeat the removal procedure. For more information, see “Verifying Removal of the SFM Software” on page 38.

		Removing the Software Using the CLI
		To remove the SFM software from your system, complete the following
		steps:
Step	1.	Log in to the system as a superuser.
Step	2.	Enter the following command at the HP-UX command prompt:

Chapter 2