HP ZT1100 manual Pca, Usb

Component

Doors, PCMCIA

Fan

Guide, hard disk drive

Heatsink

Keyboard

Module, CPU

PCA, CD player

PCA, inverter

PCA, motherboard

PCA, USB

Removal Procedure

Plug-in module (page 2-5).

Hard disk drive (page 2-6).

Keyboard cover (page 2-9).

Keyboard (page 2-11).

SDRAM modules (page 2-13).

Mini-PCI card (page 2-16).

Display assembly (page 2-18).

Fan and heatsink (page 2-22).

CPU module (page 2-25).

Top case (page 2-27).

Hinge saddles (page 2-30).

Motherboard (page 2-32).

See page 2-22.

Keyboard cover (page 2-9).

Keyboard (page 2-11).

Display assembly (page 2-18).

Top case (page 2-27).

See page 2-22.

See page 2-11.

See page 2-25.

Keyboard cover (page 2-9).

Keyboard (page 2-11).

Display assembly (page 2-18).

Top case (page 2-27).

See page 2-20.

See page 2-32.

Keyboard cover (page 2-9).

Keyboard (page 2-11).

Display assembly (page 2-18).

Top case (page 2-27).

Hinge saddle, left (page 2-30).

Additional Steps

See Figure 2-25 on page 2-35.

Remove the retaining screws, and lift the guide off of the motherboard.

Remove both retaining screws, and lift the PCA out of the top case.

Reassembly Notes: Make sure the alignment holes in the PCA (at the left end and above the right screw) fit over the corresponding posts in the top case. Make sure the PCA’s ribbon cable is securely connected to the PCA.

Carefully lift the PCA off of its connector and out of the notebook.

Reassembly Notes: Make sure the headphone jack fits through its opening in the bottom case, and that the PCA is set securely on its connector.

2-38 Removal and Replacement HP Pavilion zt1100/xz100 Omnibook xt1000