Driving
Starting the engine with a weak battery
If the battery is too weak to start the engine, it should be recharged. Charge the battery for 4 hours at max. 3 amp.
When the battery is fully charged, connect the red cable to the positive pole (+pole) of the battery and the black cable to the negative pole
When jump leads are used for emergency starting, follow the procedure below:
IMPORTANT INFORMATION Your Rider is
!equipped with a
Connecting the jump leads
•Connect each end of the red cable to the POSITIVE pole
(+) on each battery, exercise care not to short circuit any of the ends against the chassis.
Connect one end of the black cable to the NEGATIVE pole
•Connect the other end of the black cable to a good CHASSIS EARTH, away from the fuel tank and the battery.
Remove the cables in the reverse order
•The BLACK cable is removed from the chassis and then the fully charged battery.
•Finally the RED cable from both batteries.
Driving the Rider
1Release the parking brake by first pressing down the parking brake pedal and then releasing it.
Carefully press down one of the pedals until the required speed is obtained. Pedal (1) is used to drive forwards, and pedal (2) to drive backwards.
1 
2 
2Select the required cutting height
It is important that the air pressure in both front wheels is equal, 60 kPa / 0,6 bar / 8.7 PSI, to produce an even cutting height.
3 Lower the cutting unit.
IMPORTANT INFORMATION
The life span of the drive belts is increased significantly if the engine runs at a low speed when the blades are engaged. Therefore apply full throttle first when the cutting unit has been moved to the mowing position.
16 – English
