Husqvarna R120S manuel dutilisation Maintenance schedule, Interval in hours, 200

Maintenance

Maintenance schedule

The following is a list of the maintenance which should be conducted on the machine. For those points not described in this manual, visit an authorised service workshop.

Maintenance	Daily maintenance	At least once		Maintenance
	before starting	a year	interval in hours
			25		50	100	200
Cleaning	X
Check the engine’s oil level	X
Check the engine’s cooling air intake	X
Check the steering wires	X
Check the battery	X
Check the safety system	X
Check nuts and screws	O
Check for fuel and oil leakage.	O
Clean around the muffler	O
Change engine oil 1)			X		X
Replace the air filter’s prefilter2)			X
Check the cutting deck			X
Check the tire pressures.			X
Lubricate joints and shafts 3)			X
Check the V-belts			O
Checking and adjusting of throttle wire					X
Replace the air filter’s pre-filter and paper filter 2)						X
Replace the fuel filter						X
Replace the spark plug.						X
Check the fuel hose. Replace if necessary .4)		O

1)First change after 8 hours. When operating with a heavy load or at high ambient temperatures, replace every 25 hours. 2)Clean and replace the filter more often in dusty conditions. 3)If the machine is used daily it should be lubricated twice a week. 4)Conducted by authorised service workshop.

X = Described in this operator's manual

O = Not described in this operator's manual

WARNING! No service procedures must be

!conducted on the engine or cutting unit unless:

The engine is switched off. The ignition key is removed.

The ignition cable has been removed from the spark plug.

The parking brake is applied. The cutting unit is disengaged.

18 – English