Updating the device driver for a DOS network server
If you are using the CD-ROM drive in a DOS network server you need to make the
following changes:
1. Add the /S parameter to the MSCDEX line in the AUTOEXEC.BAT file.
2. Verify that the MSCDEX line is located after the line that loads the network
services (NET START for IBM PC LAN program).
3. Do one of the following, depending on your operating system:
If you are using DOS 3.3, be sure you have PC Local Area Network (LAN)
Program Corrective Service Diskette level IP00755 or later installed.
If you are using DOS 4.0, be sure you have DOS Corrective Service Diskette
level UR 29015 or later installed. (The computer cannot be configured as an
Extended Services Domain Controller for the IBM PC LAN Program.)
Contact your IBM reseller for more information about the PC LAN Program
Corrective Service Diskette or the DOS Corrective Service Diskette.
OS/2 software
User requirements vary, and you might need to customize the setup that DDINSTAL
has installed on your computer. This section provides information and describes
parameters that you might need to change or add for your installation.
Device manager driver
OS/2 uses the OS2CDROM.DMD device driver
DEVICE=OS2CDROM.DMD [Options]
to control all CD-ROM devices. The following options are available:
/V Instructs the computer to display the installation details.
/Q Suppresses messages during initialization.
Device driver filter
OS/2 uses the device driver filter IBMIDECD.FLT for ATAPI (IDE) CD-ROM drives.
BASEDEV=IBMIDECD.FLT [Options]
The following option is available:
/V Instructs the computer to display installation details.
Installable file system driver
The file system driver for OS/2 is CDFS.IFS. The following options are available:
/C:nIndicates how many 64 KB RAM segments will be used for the sector cache.
The default is two 64 KB RAM segments.
3-6 40X-17X InternalIDE CD-ROMDrive