IBM 390E manual Plastic, 180, Replacement Notice, Logic

LCD	FRU	Replacement Notice:					The TFT LCD
for	the		notebook		computer		contains		over	2,359,296
film	transistors			(TFTs).		A small number			of	missing,
ored,		or	lighted		dots	(on all the time) is cha
TFT	LCD	technology,			but	excessive		pixel		problems c
cause		viewing		concerns.		The	LCD	should		be replac

the number of missing, discolored, or lighted do background is:

ŸSVGA (12.1"): 5 or more bright dots, 5 or m

dots, or a total of 9 or more bright and

ŸXGA (13.3"/14.1"): 8 or more bright dots, 8 dark dots, or a total of 9 or more bright

Replacing the system Board: When you

replace the system board, restore the system number using the RFID Utility and reassign the the Flash UUID Utility in the ThinkPad 390E CE Diskette. See “Writing the RFID Data” on page 4 “Flash UUID” on page 49 respectively.

Note: Do not power off the computer while resto RFID.

Screw Notices: When you service this machine, the following,

Ÿ Keep the screw kit (P/N 12J0808) in your too

ŸAlways use new screws. Plastic-coated screws cannot be reused.

ŸUse a torque screwdriver if possible.

Screw Tightening Information p.Loose screws

can cause a reliability problem. The IBM ThinkPad compute addresses this problem with plastic-coate screws. Tighten screws as follows,

Plastic		to	plastic	Turn	an		additional
				90	degrees		after
				the	screw			head
				touches			the
				surface			of	the
				plastic			part.
Logic	card	to	plastic	Turn	an		additional
				180	degrees			after
				the	screw			head
				touches			the
				surface			of	the log
				card.
Torque	driver			If	you		have		a
				torque		driver,			refe
				to	the		torque
				instructions				with
				each		step.

ThinkPad 390E 61