Toshiba qosmio f10 manual Replacement Procedures Heat sink/CPU, Installing the heat sink/CPU

4 Replacement Procedures 4.15 Heat sink/CPU

2.Unlock the CPU by rotating the cam on the CPU socket 180 degrees to the counterclockwise with a flat-blade screwdriver.

3.Remove the CPU.

Cam

Figure 4-29 Removing the CPU

Installing the heat sink/CPU

The following describes the procedure for installing the heat sink and CPU (See Figure 4-28 to 4-30).

1.Check that the mark of cam is in the unlocking position.

2.Attach the CPU to the correct position in the CPU socket.

3.Fix the CPU by rotating the cam 180 degrees to the clockwise with a flat-blade screwdriver.

4.If there is already silicon grease on the CPU, clean it with a cloth.

Using a special applicator, apply silicon grease so that the CPU chip on the CPU is completely covered.

QOSMIO F10 Maintenance Manual (960-498) 4-45