Toshiba qosmio f10 manual Debug port Boot mode error status 6/9, Pciconfiguration

2 Troubleshooting Procedures 2.4 System Board Troubleshooting

Table 2-4 Debug port (Boot mode) error status (6/9)

D port status	Inspection items	Details
F107h	PCI bus initialization (connection
	of DS Bus)
	Initialization of LAN information
	Check of WakeUp factor
F108h	Task generation for waiting
	INIT_PCI completion
	CMOS data initialization (2)
	PnP initialization
	Setting of setup items
	Waiting for the completion of
	Multi-box status check (for models
	supporting Selectable bay)
	H/W setting based on resource
F109H	Task generation for waiting PnP
	resource making completion
	Serial interruption control	(before use of interruption) (for models
		supporting YEBISU)
	PnP H/W initialization	PC card slot initialization
		SIO initialization (for models supporting SIO)
		FIR initialization (for models supporting FIR)
	PCI automatic configuration	Making of work for automatic configuration
		Acquisition of PCI IRQ
		Configuration
		Saving of VGA configuration result
F10Ah	Task generation for waiting
	PCI_CONFIGURATION
	completion
	Initialization of H/W needed after	Printer port setting (for models supporting
	PCI configuration	printer)
		HDD initialization sequence start
		FDD initialization sequence start (for models
		supporting built-in FDD)
	Enabling power off
	Output code generation
F10Bh	FIRST_64KB_CHECK	(Check of first 64KB memory)
F10Ch	INIT_INT_VECTOR	(Initialization of vectors)

QOSMIO F10 Maintenance Manual (960-498) 2-25