FARGO Electronics Inc.
2.8Output Errors
2.8.1Cards feed into the Output Stacker, but are not lifted up into place.
∙Check operation by resetting the printer and visually confirming that the stacker cycles on power- up.
∙Verify that the wires (840121) from the Output Stacker are connected properly and are well seated in the wire harness.
∙Ensure that the Output Stacker is set to the correct card size. Slide the wall of the Output Stacker to the correct card size.
∙Test the operation of the Stacker Lift Motor by disconnecting the cable connector, and connecting a 9V battery to the wires. If the motor does not turn, replace the motor. If the motor does turn, the Lam Board may need to be replaced as described in Section 4.9.4
HDP700 Series Card Printer |
