FARGO Electronics Inc.

5.Bring the Transfer Station up and forward.

6.Remove the four screws (F000034) from the Front Transfer Station Cover.

7.Lift off the Front Transfer Station Cover.

8.Remove the two screws (F000034) from the bottom of the Base Module Cover.

9.Open the Front Access Door of the Card Input Hopper and the Card Output Hopper Door.

10.Remove the two screws (F000034) from each side of the Base Module Cover.

11.Rotate the Transfer Station to a 45° angle.

12.Pull the Base Module Cover carefully up and out of the printer.

13.Loosen the set screws on the pulleys.

14.Remove the Drive Pulleys (D850190) and belts from the shaft simultaneously.

4.6.10Drive Pulley — Back -- 2 (D850190)

Refer To Drawing 840151

Tools Needed

Torx T-10 Screwdriver, Standard Screwdriver, 1.5mm Allen Wrench, Phillips-head Screwdriver

1.Turn off the printer and unplug the power cord from the printer.

2.Remove the screws from the Back Cover of the printer.

3.Tilt the Back Cover outwards from the printer.

4.Remove the four screws that secure the Rear Bracket (D840585) to the printer.

5.Detach the cables running to the board.

6.Remove the screw from the Gas Spring (840366) and take off the Washers (130283 and 140040).

7.Set the Back Cover carefully aside.

8.Loosen the two screws from the belt tensioner.

9.Pull the tensioner back against spring to relieve tension from the belt and tighten the screws to hold the tensioner in place.

10.Remove the screw from the linkage

11.Use a standard screwdriver to remove the clip from the pulley

12.Remove the belts from the pulleys.

13.Pull the Drive Pulley (D850190) from the printer.

4-28

HDP700 Series Card Printer

Page 86
Image 86
FARGO electronic HDP700 manual Drive Pulley Back -- 2 D850190