FARGO electronic HDP700 manual Replacing the Power Assembly Components, Power Switch

FARGO Electronics Inc.

4.9Replacing the Power Assembly Components

Follow the procedures in this Section to replace the Power Module components.

4.9.1Power Switch (120011)

Refer To Drawing 840161

Tools Needed

Torx T-10 Screwdriver, Needle Nose Pliers, Phillips-head Screwdriver

1.Turn off the printer and unplug the power cord from the printer.

2.Remove the screws from the Back Cover of the printer.

3.Tilt the Back Cover outwards from the printer.

4.Remove the two screws (130314) from the Power Supply Cover.

5.Remove the Power Supply Cover.

6.Unplug the Power Supply Cable, the black wires leading into the white plug on the top of the board.

7.Use the Needle Nose Pliers to unplug the cables that run to the Power Switch and the Line Filter

NOTE

The cable connectors labeled D840511 goes to the top two connectors; cable D840512 goes to the lower two connectors for the Line Filter.

8.Depress and hold the tabs on the top and bottom of the Power Switch.

9.Push the Power Switch out of the printer.

4.9.2Power Cord Receptacle

(130067)

Refer To Drawing 840161

Tools Needed

Torx T-10 Screwdriver, Needle Nose Pliers, Phillips-head Screwdriver

1.Turn off the printer and unplug the power cord from the printer.

2.Remove the screws from the Back Cover of the printer.

3.Tilt the Back Cover outwards from the printer.

4.Remove the two screws (130314) from the Power Supply Cover.

5.Remove the Power Supply Cover.

6.Unplug the Power Supply Cable.

7.Use the Needle Nose Pliers to unplug the cables that run to the Line Filter (130067). Remove the Ground Screw (D840510).

4-46 HDP700 Series Card Printer