FARGO electronic HDP700 manual Transfer Lift Switch, Transfer Lift Motor

FARGO Electronics Inc.

4.5.13Transfer Lift Switch (840142)

Refer to drawing 840159

Tools Required

Torx T-10 Screwdriver, Wire Cutter, 1.5 mm Allen Wrench, Phillips-head Screwdriver

1.Turn off the printer and unplug the power cord from the printer.

2.Open the Front Access Door.

3.Push the Release Lever down to unlock it.

4.Move the Print Station up and back

5.Bring the Transfer Station up and forward.

6.Remove the four screws (F000034) from the Front Cover

7.Lift off the Front Cover.

8.Remove the two screws (F000169) from the Rear Transfer Cover.

9.Lift off the Rear Transfer Cover.

10.Loosen the setscrew on the blue hand wheel; lift off the blue hand wheel.

11.Remove the Washer (130997) from the Encoder Wheel.

12.Slide the Encoder Wheel gently off of the shaft.

13.Remove the C-clip from the idler gear and remove the idler gear.

14.Remove the C-clip from the combination pulley/gear and remove the combination pulley/gear.

15.Remove the two screws from the rear side of the Transfer module that hold the Lamination assembly.

16.Cut the wire tie on the front side of the Transfer module.

17.Remove the two screws from the front of the Transfer module that hold the Lamination assembly.

18.Disconnect all wires that run to the Lamination assembly.

19.Remove the Lamination assembly.

20.Remove the screw (130972) that holds the Transfer Lift Switch.

21.Unplug the cable connector.

4.5.14Transfer Lift Motor (840132)

Refer to drawing 840159

Tools Required

Torx T-10 Screwdriver, Wire Cutter, 1.5 mm Allen Wrench, Phillips-head Screwdriver

1.Turn off the printer and unplug the power cord from the printer.

2.Open the Front Access Door.

HDP700 Series Card Printer 4-21