FARGO electronic HDP700 manual Pinch Roller Spring Plate-Back -- 2

FARGO Electronics Inc.

14.Take the Spring Plate from the printer.

4.6.6Pinch Roller Spring Plate-Back -- 2 (840354)

Refer To Drawing 840151

Tools Needed

Long-handled, magnetic Phillips-head Screwdriver, Torx T-10 Screwdriver

1.Turn off the printer and unplug the power cord from the printer.

2.Remove the screws from the Back Cover of the printer.

3.Tilt the Back Cover outwards from the printer.

4.Remove the four screws that secure the Rear Bracket (D840585) to the printer.

5.Detach the cables running to the board.

6.Remove the screw from the Gas Spring (840366) and take off the Washers (130283 and 140040).

7.Set the Back Cover carefully aside.

8.Remove the screw from the Spring Plate

9.Take the Spring Plate from the printer.

4.6.7Drive Belt-Tensioner to Platen Roller

(F000003)

Refer To Drawing 840151

Tools Needed

Standard Screwdriver, Torx T-10 Screwdriver, Phillips-head Screwdriver

1.Turn off the printer and unplug the power cord from the printer.

2.Remove the screws from the Back Cover of the printer.

3.Tilt the Back Cover outwards from the printer.

4.Remove the four screws that secure the Rear Bracket (D840585) to the printer.

5.Detach the cables running to the board.

6.Remove the screw from the Gas Spring (840366) and take off the Washers (130283 and 140040).

7.Set the Back Cover carefully aside.

8.Loosen the two screws to the tensioner.

9.Pull the tensioner back against spring to relieve tension from the belt.

10.Remove the belt from the pulley.

4-26 HDP700 Series Card Printer