FARGO electronic HDP700 manual Clutch Spring 840285, Card Sensor Assembly-Flipper Table D840624

FARGO Electronics Inc.

4.Remove the five screws from the base of the Card Input Hopper Cover and remove the other four screws (on the right side) of the printer.

5.Lift the Card Input Hopper Cover off of the printer.

6.Use the small standard screwdriver to remove the Retaining Ring (140062) from the Card Feed Shaft Gear.

7.Remove the three screws (130315) from the Card Feed Motor Assembly.

8.Lift the Card Feed Motor Assembly from the printer.

4.8.10Clutch Spring

(840285)

Refer To Drawing 840156

Tools Needed

Phillips-head Screwdriver, Small Standard Screwdriver

1.Turn off the printer and unplug the power cord from the printer.

2.Open the Front Access Door.

3.Detach the LCD Interface Cable (D840517) from the HD7XXX User Interface Board Assembly (140403).

4.Remove the five screws from the base of the Card Input Hopper Cover and remove the other four screws from inside the print station.

5.Lift the Card Input Hopper Cover off of the printer.

6.Use the small standard screwdriver to remove the Retaining Ring (140062) from the one-way Pulley (840215).

7.Slide the one-way pulley from the shaft.

8.Slide the Clutch Spring (840285) from the shaft.

4.8.11Card Sensor Assembly-Flipper Table

(D840624)

Refer To Drawing 840156

Tools Needed

1.5mm Allen Wrench, Phillips-head Screwdriver, Torx T-10 Screwdriver

1.Turn off the printer and unplug the power cord from the printer.

2.Open the Front Access Door.

3.Detach the LCD Interface Cable (D840517) from the HD7XXX User Interface Board Assembly (140403).

4.Remove the five screws from the base of the Card Input Hopper Cover and remove the other four screws from inside the print station.

5.Lift the Card Input Hopper Cover off of the printer.

6.Loosen the belt tensioner

7.Remove the pulley from the front of the printer.

HDP700 Series Card Printer 4-43