FARGO electronic HDP700 manual Pinch Roller Spring Plate-Front Input Side

FARGO Electronics Inc.

4.7.4Pinch Roller Spring Plate-Front Input Side (840354)

Refer To Drawing 840151

Tools Needed

Phillips-head Screwdriver, Torx T-10 Screwdriver, 1.5mm Allen Wrench

1.Turn off the printer and unplug the power cord from the printer.

2.Open the Front Access Door.

3.Push the Release Lever down to unlock it.

4.Lift the Print Station up and back.

5.Bring the Transfer Station up and forward.

6.Remove the four screws (F000034) from the Front Transfer Station Cover.

7.Lift off the Front Transfer Station Cover.

8.Remove the two screws (F000034) from the bottom of the Base Module Cover.

9.Open the Front Access Door of the Card Input Hopper and the Card Output Hopper Door.

10.Remove the two screws (F000034) from each side of the Base Module Cover.

11.Rotate the Transfer Station to a 45° angle.

12.Pull the Base Module Cover carefully up and out of the printer.

13.Remove the screw from the Spring Plate.

14.Take the Spring Plate from the printer.

4.7.5Pinch Roller Spring Plate-Front Output Side (840354)

Refer To Drawing 840151

Tools Needed

Phillips-head Screwdriver, Torx T-10 Screwdriver

1.Turn off the printer and unplug the power cord from the printer.

2.Open the Front Access Door.

3.Push the Release Lever down to unlock it.

4.Lift the Print Station up and back.

5.Bring the Transfer Station up and forward.

6.Remove the four screws (F000034) from the Front Transfer Station Cover.

7.Lift off the Front Transfer Station Cover.

8.Remove the two screws (F000034) from the bottom of the Base Module Cover.

9.Open the Front Access Door of the Card Input Hopper and the Card Output Hopper Door.

10.Remove the two screws (F000034) from each side of the Base Module Cover.

11.Rotate the Transfer Station to a 45° angle.

HDP700 Series Card Printer 4-33