FARGO electronic HDP700 manual Transfer Ribbon Peel Off Bar Assembly D840698, Ribbon Drive Hub 2

FARGO Electronics Inc.

NOTE

The plastic Head Location Guide (840246) and Spring (F000007) are positioned on the shaft; take care to keep track of them for installation of the new Platen Roller.

Examine the new Platen Roller to ensure that it is free from surface defects before installing it. Be sure to install the wide metal neck of the shaft at the front end of the Platen Roller. Once the new Platen Roller Assembly is installed, evacuate the mid- Section of the printer with canned air to remove dust and debris.

4.5.9Transfer Ribbon Peel Off Bar Assembly (D840698)

Refer To Drawing 840159

Tools Needed

Torx T-10 Screwdriver

1.Turn off the printer and unplug the power cord from the printer.

2.Open the Front Access Door.

3.Push the Release Lever down to unlock it.

4.Lift the Print Station up and back.

5.Rotate the Transfer Station outward.

6.Remove the two screws (F000191).

7.Take the Peel Off Bar out of the printer.

NOTE

From the front of the HDP Card Printer, the Peel-Off Bar on the input side should be flush with the frame; the Ribbon Peel Bar on the output side should have a 3/16-in. (4.5mm) gap between the frame and the Ribbon Peel Bar.

4.5.10Ribbon Drive Hub — 2 (840324)

Refer To Drawing 840152

Tools Needed

Phillips-head Screwdriver, Torx T-10 Screwdriver, Standard Screwdriver

1.Turn off the printer and unplug the power cord from the printer.

2.Open the Front Access Door.

3.Push the Release Lever down to unlock it.

4.Lift the Print Station up and back.

5.Bring the Transfer Station up and forward.

6.Remove the four screws (F000034) from the Front Cover.

7.Lift off the Front Cover.

8.Remove the two screws (F000034) from the Rear Transfer Cover.

4-18 HDP700 Series Card Printer