FARGO electronic HDP700 manual Belt F000018, Base Module

FARGO Electronics Inc.

4.6.11Belt (F000018)

Refer To Drawing 840151

Tools Needed

1.5mm Allen Wrench, Torx T-10 Screwdriver, Phillips-head Screwdriver

1.Turn off the printer and unplug the power cord from the printer.

2.Remove the screws from the Back Cover of the printer.

3.Tilt the Back Cover outwards from the printer.

4.Remove the four screws that secure the Rear Bracket (D840585) to the printer.

5.Detach the cables running to the board.

6.Remove the screw from the Gas Spring (840366) and take off the Washers (130283 and 140040).

7.Set the Back Cover carefully aside.

8.Pull the tensioner back against spring to relieve tension from the belt and tighten the screws to hold the tensioner in place.

9.Use the standard screwdriver to remove the clip from the idler drive pulley.

10.Remove the belt from the idler gear and the platen drive pulley.

11.Use the standard screwdriver to remove the clip from the platen roller shaft.

12.Take the Pulley (F000006) and the belt from the shaft.

13.Loosen the two Allen-head screws on the middle Pulley (F000006).

14.Remove the pulley from the shaft.

15.Remove the belt from the printer.

NOTE

Ensure that the new Belt is pulled taut and securely in place; if the Belt is not tight, the printer will not function properly.

4.6.12Base Module (840151)

Refer To Drawing 840151

Tools Needed

Torx T-10 Screwdriver, Standard Screwdriver Phillips-head Screwdriver

16.Turn off the printer and unplug the power cord from the printer.

17.Remove the screws from the Back Cover of the printer.

18.Tilt the Back Cover outwards from the printer.

19.Remove the four screws that secure the Rear Bracket (D840585) to the printer.

20.Detach the cables running to the boards.

HDP700 Series Card Printer 4-29