FARGO electronic HDP700 manual Replacing the Print Station Components, Rings 140212

FARGO Electronics Inc.

4.4Replacing the Print Station Components

Follow the procedures in this Section to replace the Print Station components.

4.4.1O-Rings

(140212)

Headlift Drive O-Ring

Refer To Drawing 840153

Tools Needed

Phillips-head Screwdriver, Small Standard Screwdriver

1.Turn off the printer and unplug the power cord from the printer.

2.Open the Front Access Door.

3.Push the Release Lever down to unlock it.

4.Lift the Print Station up and back.

5.Remove the four screws (F000034) from the Print Station Cover of the printer.

6.Lower the Print Station back into position.

7.Lift the Print Station Cover off of the printer.

8.Use the small standard screwdriver to remove the Retaining Ring (140061) from the Pulley Gear Combo (760287).

9.Slide the Pulley Gear Combo from the shaft.

10.Remove the O-Ring.

Ribbon Drive O-Ring Behind the Encoder Wheel (810492)

Refer To Drawing 840153

Tools Needed

Phillips-head Screwdriver, Small Standard Screwdriver

1.Turn off the printer and unplug the power cord from the printer.

2.Open the Front Access Door.

3.Push the Release Lever down to unlock it.

4.Lift the Print Station up and back.

5.Remove the four screws (F000034) from the Print Station Cover of the printer.

6.Lower the Print Station back into position.

7.Lift the Print Station Cover off of the printer.

8.Use the standard screwdriver to take the Retainer Clip (897144) from the Encoder Wheel (810492).

9.Remove the Washer (130997) from the Encoder Wheel.

HDP700 Series Card Printer 4-9