FARGO Electronics Inc.

4.8.7Cleaning Roller Assembly (840102)

Refer To Drawing 840156

Tools Needed

None

1.Open the Front Access Door.

2.Press the tab on the Cleaning Roller Assembly

3.Pull the Cleaning Roller Assembly from the printer.

4.8.8Flipper Table Position Stepper Motor

(840124)

Refer To Drawing 840156

Tools Needed

Phillips-head Screwdriver, Torx T-10 Screwdriver

1.Turn off the printer and unplug the power cord from the printer.

2.Open the Front Access Door.

3.Detach the LCD Interface Cable (D840517) from the HD7XXX User Interface Board Assembly (140403).

4.Remove the five screws from the base of the Card Input Hopper Cover and remove the other four screws from inside the print station.

5.Lift the Card Input Hopper Cover off of the printer.

6.Remove the screws from the Back Cover of the printer.

7.Tilt the Back Cover outwards from the printer.

8.Remove the screws from the back plate and move it far enough to allow access to the back of the hopper assembly.

9.Disconnect the Stepper Motor Cable connection.

10.Remove the two screws (130314) that secure the Stepper Motor.

11.Lift the Stepper Motor carefully from the printer.

4.8.9Card Feed Motor Assembly (840198)

Refer To Drawing 840156

Tools Needed

Small Standard Screwdriver, Phillips-head Screwdriver, Torx T-10 Screwdriver

1.Turn off the printer and unplug the power cord from the printer.

2.Open the Front Access Door.

3.Detach the LCD Interface Cable (D840517) from the HD7XXX User Interface Board Assembly (140403).

4-42

HDP700 Series Card Printer

Page 100
Image 100
FARGO electronic HDP700 Cleaning Roller Assembly, Flipper Table Position Stepper Motor 840124, Card Feed Motor Assembly