FARGO electronic HDP700 manual Main Print Board A000030, Lamination Board

FARGO Electronics Inc.

8.Remove the two screws (130971) and nuts (130985) located on each side of the outside of the Power Cord Receptacle.

9.Remove the Power Cord Receptacle.

4.9.3Main Print Board

(A000030)

Refer To Drawing 840161

Tools Needed

Torx T-10 Screwdriver, Phillips-head Screwdriver

1.Turn off the printer and unplug the power cord from the printer.

2.Remove the screws from the Back Cover of the printer.

3.Tilt the Back Cover outwards from the printer.

4.Unplug the cable connections to the Main Board.

5.Remove the five screws (F000169) that secure the Main Board to the Rear Bracket (D840585).

6.Take the Main Board from the printer.

NOTE

Refer to Table 4-1 for cable connections.

4.9.4Lamination Board (140402)

Refer To Drawing 840161

Tools Needed

Torx T-10 Screwdriver, Phillips-head Screwdriver

1.Turn off the printer and unplug the power cord from the printer.

2.Remove the screws from the Back Cover of the printer.

3.Tilt the Back Cover outwards from the printer.

4.Unplug the cable connections to the Lamination Board.

5.Remove the four screws (F000169) that secure the Lamination Board.

6.Lift the Lamination Board from the printer.

NOTE

Refer to Table 4-1 for cable connections.

HDP700 Series Card Printer 4-47