FARGO electronic HDP700 manual Pinch Roller Spring Plate-Back Input Side 840354

FARGO Electronics Inc.

12.Pull the Base Module Cover carefully up and out of the printer.

13.Remove the screw from the Spring Plate.

14.Take the Spring Plate from the printer.

4.7.6Pinch Roller Spring Plate-Back Input Side

(840354)

Refer To Drawing 840151

Tools Needed

Torx T-10 Screwdriver

1.Turn off the printer and unplug the power cord from the printer.

2.Remove the screws from the Back Cover of the printer.

3.Tilt the Back Cover outwards from the printer.

4.Remove the four screws that secure the Rear Bracket (D840585) to the printer.

5.Detach the cables running to the board.

6.Remove the screw from the Gas Spring (840366) and take off the Washers (130283 and 140040).

7.Set the Back Cover carefully aside.

8.Remove the screw from the Spring Plate.

9.Take the Spring Plate from the printer.

4.7.7Pinch Roller Spring Plate-Back Output Side

(840354)

Refer To Drawing 840151

Tools Needed

Torx T-10 Screwdriver, 1.5mm Allen Wrench

1.Turn off the printer and unplug the power cord from the printer.

2.Remove the screws from the Back Cover of the printer.

3.Tilt the Back Cover outwards from the printer.

4.Remove the four screws that secure the Rear Bracket (D840585) to the printer.

5.Detach the cables running to the board.

6.Remove the screw from the Gas Spring (840366) and take off the Washers (130283 and 140040).

7.Set the Back Cover carefully aside.

8.Remove the screw from the Spring Plate.

9.Take the Spring Plate from the printer.

4-34 HDP700 Series Card Printer