Flash (BIOS/VPD) update procedure
Attention
Refer to the information label located inside the
system unit cover for any model-specific information.
1. Power-off the computer.
2. Insert the flash update diskette into drive A.
3. Power-on the computer.
4. When the Update Utility appears; select your
country/keyboard, then press Enter.
5. If the computer serial number was previously
recorded, the number is displayed with an option to
update it. Press Y to update the serial number.
6. Type the 7-digit serial number of the computer you
are servicing; then, press Enter.
7. Follow the instructions on the screen to complete the
flash (BIOS/VPD) update procedure.
Flash recovery boot block
Attention
If an interruption occurs during a Flash/BIOS upgrade,
the BIOS might be left in an unusable state. The Boot
Block jumper enables you to restart the system and
recover the BIOS.
To perform a Flash/BIOS recovery using the recovery
jumper:
1. Power-off the computer and remove the cover.
2. Move the system board recovery jumper to the clear
position. Refer to “System board layout” on page 77
or the information label inside the computer for more
information.
3. Insert the upgrade diskette into the diskette drive.
4. Power-on the computer. The IBM Logo will appear.
5. When the Flash Update Utility appears; select your
country/keyboard, then press Enter.
6. If the computer serial number was previously
recorded, the number is displayed with an option to
update it. Press Y to update the serial number.
7. Type the 7-digit serial number of the computer you
are servicing; then, press Enter.
8. Follow the instructions on the screen to complete the
flash (BIOS/VPD) update procedure.
9. When you are instructed to reboot the computer,
power-off the computer and move the recovery
jumper to the normal position. Then, replace the
cover and power-on the computer.
54 IBM PC 300/IntelliStation Vol 3 HMM