InFocus M-300 manual Options & Accessories, Place Stamp in AN Unused Area

5-2 Options & Accessories

0 1 2 3 4 5 6 7 8 9 10 11 12 1 3

1

2

3

4

5

6

7

8

9

PLACE STAMP IN AN

UNUSED AREA

PREVIOUSLY	GRAPHICS SOFTWARE
COMPLETED
	PAGE LAYOUT
STAMPS
	11 INCHES ( 292.1 mm) WIDE
	8.5 INCHES ( 215.9 mm) TALL
	LANDSCAPE MODE

COMPUTER GRAPHICS SCREEN

Place the stamp (on screen) where you want it to engrave in laser system. Avoid the spots where you have already engraved and cut out other stamps.

0	1	2			3	4	5		6	7	8	9	1 0	11	12		13
1
2
3															SHEET OF RUBBER
4
								AREA WHERE NEW								STAMP MATERIAL
5		PREVIOUSLY					STAMP WILL ENGRAVE
6
		COMPLETED
7			STAMPS
8				LASER ENGRAVING TABLE
9

Place a sheet of rubber stamp material into the UPPER LEFT CORNER against the rulers, as the following diagram illustrates, and be sure to properly focus on the material. Now, set the printer driver settings as shown on the following page.