Intel® Server Boards S5000PSL and S5000XSL TPS | Design and Environmental Specifications |
Intel® Embedded Server RAID Technology functionality requires the following items:
•Intel® ESB-2 IO Controller Hub
•Intel® Embedded Server RAID Technology Option ROM
•Intel® Embedded Server RAID Technology II drivers, most recent revision
•At least two SATA hard disk drives
Intel® Embedded Server RAID Technology is not available in the following configurations:
•The SATA controller in compatible mode
•Intel® Embedded Server RAID Technology II has been disabled
3.2.2.2Intel® Embedded Server RAID Technology Option ROM
The Intel® Embedded Server RAID Technology for SATA Option ROM provides a pre-OS user interface for the Intel® Embedded Server RAID Technology implementation and provides the ability for an Intel® Embedded Server RAID Technology volume to be used as a boot disk as well as to detect any faults in the Intel® Embedded Server RAID Technology volume(s) attached to the Intel® RAID controller.
3.2.3Parallel ATA (PATA) Support
The integrated IDE controller of the ESB2-E ICH6 provides one IDE channel. It redefines signals on the IDE cable to allow both host and target throttling of data and transfer rates of up to 100 MB/s. For this server board, the IDE channel was designed to provide optical drive support to the platform. The BIOS initializes and supports ATAPI devices such as LS-120/240, CD-ROM, CD-RW and DVD-ROM. The IDE channel is accessed through a single standard 40- pin IDE connector (J2J2) that provides the I/O signals. The ATA channel can be configured and enabled or disabled by accessing the BIOS Setup utility during POST.
3.2.4USB 2.0 Support
The USB controller functionality integrated into ESB2-E provides the server board with the interface for up to eight USB 2.0 ports. Four external connectors are located on the back edge of the server board. One internal 2x5 header (J3J1) is provided, capable of supporting two optional USB 2.0 ports. One USB port Type A connector (J3G1) is provided to support installation of a USB device inside the server chassis. An additional USB port is dedicated to the Intel® Remote Management Module (Intel® RMM) connector.
3.3Video Support
The server board provides an ATI* ES1000 PCI graphics accelerator, along with 16 MB of video DDR SDRAM and support circuitry for an embedded SVGA video sub-system. The ATI ES1000 chip contains an SVGA video controller, clock generator, 2D engine, and RAMDAC in a 359-pin BGA. One 4M x 16 x 4-bank DDR SDRAM chip provides 16 MB of video memory.
Revision 1.2 | 45 |
| Intel order number: D41763-003 |
