Intel SE7501CW2 manual Installing Memory

Intel Server Board SE7501CW2 Installation and Integration Guide

Installing Memory

The server board supports only DDR266- compliant DIMMs. The minimum supported memory configuration is 128 MB, using one 128-MB DIMM. The maximum configurable memory size is 8 GB using 4 2-GB DIMMs.

If a single DIMM is used, you must install it in the DIMM 1A socket. Bank 1 must be fully populated before you install any memory in Bank 2, and Bank 2 only operates with two DIMMs installed. DIMMs must be identical within each bank.

Note:

Use memory that has been tested for compatibility with the server board. For a list of tested memory, see:

http://support.intel.com/support/motherboards/server/SE7501CW2/tested_mem.htm

If the server board is not already installed in the chassis, remove the server board from its packaging and place it on a clean ESD-protected work surface.

1.Open both DIMM socket levers.

2.Insert DIMM, making sure the connector edge of the DIMM aligns correctly with the slot.

3.Check that the socket levers are securely latched. DIMMs must be populated in identical pairs.

11