Making Optional Connections to the Server Board | Intel SE7501CW2

Intel Server Board SE7501CW2 Installation and Integration Guide

Making Optional Connections to the Server Board

These connections are required only when the corresponding component is installed.

A	Hot Swap Back Plane (HSBP)	C	Front Universal Serial Bus
B	System Fan 5	D	Serial B

17

Image 17

Intel SE7501CW2 manual Making Optional Connections to the Server Board

Contents

Server Installation and Integration Guide Revision History Table of Contents Administrator computers Client computers Thank you Document OverviewTarget Audience Minimum Hardware Requirements Troubleshooting Guide Hardware Integration Prepare for Assembly Electrostatic Discharge ESD Important Safety InformationSafety Instructions and Information Installing the I/O Shield Chassis Preparation and Server Board InstallationAbout the I/O Shield Attaching the Gasket to the I/O Shield Installing the Server Board Installing Chassis StandoffsInstalling the Rubber Bumper Installing Memory Choosing the Processor Socket Installing the Boxed Intel Xeon ProcessorOpening the Socket Lever Attaching the Processor Attaching the Heat Sink and Retention Clips Installing the Retention MechanismApplying Thermal Grease Attaching the Heat Sink Fan Installing the Processor Wind TunnelAttaching the Fan/Intake Assembly Attaching the Wind Tunnel Making Required Connections to the Server Board Making Optional Connections to the Server Board Installing the Serial B Cable Cable Routing Intel Server Chassis SC5200 Installing the Access CoverIDE or Scsi Cables Floppy and Front Panel Cables Installing into a Rack Rack Mode Installing the Chassis Feet Pedestal Mode Finishing Up Installing the Operating System Updating the Bios LANDesk System Requirements Installing LANDesk Client ManagerLANDesk* Client Manager Installing the Intel SMaRT Tool Thank you for purchasing Intel products