Recliners only, Solid Seat Model Wheelchairs | Invacare 96-100

S A F E T Y

&

SAFETY/HANDLING

5.Engage both wheel locks, open the footrest/ legrest for clearance and transfer into the wheel- chair. Refer to TRANSFERRING TO AND FROM OTHER SEATS in this section of the manual.

H A N D L I N G

RECLINERS ONLY

Cover of the

Folding Handle

To Fold

Folding	To Unfold
Handle

SLING SEAT MODEL WHEELCHAIRS -

UNFOLDING

FOLDING.

1.Swing footrest/legrest in locked position to the front of the wheelchair.

2.Pivot footplates upward to vertical position.

3.RECLINERS ONLY -

A.Turn the folding handle cover towards the rear of the wheelchair approximately two (2) to four (4) revolutions.

B.Slide the cover of the folding over until the links of the spreader bar are visible.

4.With both hands, grasp the middle of the seat upholstery at the front and back edge and lift up. Or, tilt the wheelchair to one side and close by the push handles.

NOTE: If wheelchair is equipped with carry straps, the wheelchair may be closed by pulling up on the straps.

RECLINERS ONLY

Cover of the

Folding Handle

To Fold

Folding	To Unfold
Handle

SLING SEAT MODEL WHEELCHAIRS -

FOLDING

Solid Seat Model Wheelchairs

1.From behind the wheelchair, grasp the right hand edge of the solid seat.

2.Raise the seat to the hinged side.

3.Swing footrest/legrest in locked position to the front of the wheelchair.

4.Pivot footplates upward to vertical position.

5.With both hands, grasp the middle of the seat upholstery at the front and back edge and lift up. Or, tilt the wheelchair to one side and close by the push handles.

SOLID SEAT MODEL WHEELCHAIRS

10

Image 10

Invacare 96-100 manual Recliners only, Sling Seat Model Wheelchairs Unfolding Folding, Sling Seat Model Wheelchairs Folding

Contents

Allegro Special Notes Special Notes Table of Contents Safety Summary Safety Summary Safety Summary Recliner Option only SAFETY/HANDLING of Wheelchairs Stairways Transferring to and from Other Seats NON-RECLINERS Percentage of Weight DistributionUnoccupied Occupied Recliners Folding and Unfolding Wheelchair SAFETY/HANDLING Functional Reach from a WheelchairBending Forward Sling Seat Model Wheelchairs Folding Recliners onlySling Seat Model Wheelchairs Unfolding Folding Solid Seat Model Wheelchairs Features FeaturesA T U R E S Specifications Specifications C K a G I N G PackagingHandling N D L I N G Safety Inspection Checklist Safety Inspection Check List Maintenance TroubleshootingI N T E N a N C E Adjusting Footrest Height Procedure Front RiggingsInstalling Footrests Figure Pivot Slide Tube Height Adjustment Figure Procedure Installing 3-INCH Extension FigureInstalling Elevating Legrests Figure Raising/Lowering Elevating Legrests Installing Adjustable Angle Flip-up Footplates Figure Adjusting CalfpadsINSTALLING/ADJUSTING Adjustable Angle FLIP-UP Footplates Adjustable Angle Flip-up Footplate Depth Adjustment Figure FLIP-UP Footplates Figure Optional Footrest AccessoriesReplacing Sector Block Figure Aluminum or Composite Footplates Figure Installing Procedure ArmsM S Height Figure Adjusting the T ArmsRemoving Width Figure Arm Sockets Figure Reposition the arm tube on the T arm postArm Hex Screws Washers Top Middle Bottom Side Arm Guard Arms ProcedureReplacing the Locking Lever T Arms Figure Socket Screws Bottom Clamp Installing/Height Adjustment Figure Using FigureCorresponding Arm Adjustment to Back Angle Figures 10 Angled Portion Cantilever Arm AdjustmentReplacement Locking Mechanism Actuator Apply Loctite Installing Rigid Side Guards Figure Installing Fabric Clothing Guards FigureAdjusting Conventional Arm Height Removing Conventional Arms Rear Arm Sockets Figure Replacing Armrest Pads FigureFront Arm Sockets Figure C K Procedure BackInstalling Adjustable Back Upholstery Figure Replacing Back Upholstery Replacing Adjustable Back Upholstery Figure Adjustable Tension Straps Back Upholstery Cover WHY USE Adjustable Back Upholstery a Clinical DiscussionBack upholstery cover is designed for three 3 reasons Recliner Back Upholstery Figure Adjusting the Back HeightAdjustable Height Backs Figure Recliner Headrest Upholstery Figure Slowly remove the two 2 backs canes from the wheelchair Fixed Height Backs FigureBack Cane Hex Bolt Washer Back Angle Plate Locknut Replacing the Locking Mechanism in the Back Cane Figure Back Plate Changing the Back AngleRepositioning the Back Changing Seat Depth Non-Recliners Figure Back Angle Plate Hex Bolt Locknut Wheelchair Frame Washer Recliners Figure Recliner Brackets Installing and Removing a Seating SystemReplacing Folding Push Handle Recliners only Figure CHANGING/REPOSITIONING Seat Rails Figure A TSeat Replacing Seat Upholstery Figure Changing Seat Width Procedure SeatRepositioning the Crossbraces Figure Standard Folding Frames Figure Crossbraces For installation of newPivot Link Folding Frames Without Seat Rails Figure Rigid Frames Figure Hex Bolt Seat Width HolesCrossmembers Wheelchair Frame Washer Hex Screws Casters S T E R SReplacing Front Fork Figure Inline Caster Headtubes Figure REPLACING/REPAIRING Front Caster TIRE/TUBECasters Offset Caster Headtubes Figure Repositioning the Caster Headtubes Caster Headtube Mounting Adjustments FigureHeight Adjustment Inline Caster Headtube Hardware Offset Dust Release Detent Pin Installing QUICK-RELEASE Casters FigureCover Headtube Locknut Cap Spacer Fork Stem Hex Screw A R REMOVING/INSTALLING Rear Wheels FigureAdjusting the QUICK-RELEASE Axle Figure Rear Wheels Justing the QUAD-RELEASE Handle Installing the QUAD-RELEASE Axle FigureAdjusting the QUAD-RELEASE Handle Figure And/or Out Spoke Rear Wheels Handrim Replacement FigureRemoving the Play From the Rear Wheels Phillips Bolt Handrim Composite Rim Locknut Installing Projection HandrimsComposite Rear Wheels Figure Spoke Rear Wheels Figure Jam Nuts REPAIRING/REPLACING Rear Wheel TIRE/ TubeAdjusting the Wheelbase Length Figure Shortening Forward Axle Adjusting the Wheelbase Width FigureAdjusting Rear Wheel Height Figure Mounting Plate E E L K S E R S Adjusting the Wheel Locks FigureWheel Lock Extension Handle Installation Figure Wheel LOCKS/ANTI-TIPPERS Adjusting the Anti-Tippers Figure Procedure Wheel LOCKS/ANTI-TIPPERSINSTALLING/ADJUSTING the ANTI-TIPPERS Installing the Anti-Tippers Figure Recliner Operation Figures 1 REPLACEMENT/ADJUSTMENTRecliner Folding/Unfolding the Wheelchair Recliner Installing New Recliner CablesActuator Housing Cable Locking Nut Trigger Release Lever Like this Replacing the GAS Cylinders FigureMust Look TOO LOW Steps 1, 5 Squeeze the handles to extend the new gas cylinders Adjusting the GAS Cylinders FigureTrigger Release Lever Cable Locking Nut Adjusting Detail B Must Look TOO LOW Minus SEAT-TO-FLOORSEAT-TO-FLOOR Height Determination Equals Changing SEAT-TO-FLOOR Height Procedure SEAT-TO-FLOORStandard MULTI-POSITION Axle Plate A T Lower Inline Caster Headtube Front SEAT-TO-FLOOR HeightsFrame Offset Caster Headtube Front SEAT-TO-FLOOR Heights Changing Seat Depth A T P T HSeat Depth Determination Figure Seat Depth Seat Depth Checklist Seat Depth Right A T P TLeft Rear Mounting Hole Approximate 2-inch gap A T P T Inch Right A T P T H Page Limited Warranty Limited WarrantyR R a N T Y One Invacare Way Technical Support