Invacare 96-100 Adjusting Calfpads, INSTALLING/ADJUSTING Adjustable Angle FLIP-UP Footplates

PROCEDURE 1 FRONT RIGGINGS

F

R O N T

R

I

G G I N G S

Adjusting Calfpads

1.To adjust the calfpad, turn pad towards the outside of the wheelchair.

2.Slide the calfpad up or down until the desired position is obtained.

3.To secure the calfpad, turn the calfpad towards the inside of the wheelchair.

INSTALLING/ADJUSTING ADJUSTABLE ANGLE FLIP-UP FOOTPLATES

WARNING

When determining the angle of the footplates, make sure the rear of the footplates do not interfere with the movement of the front casters.

Installing Adjustable Angle Flip-up Footplates (FIGURE 7)

1.Slide the half clamp over the footplate hinge.

2.Loosely tighten the two (2) flat bolts, washers and locknuts that secure the footplate to the half clamp.

3.If necessary, adjust the footplates to the necessary angle and depth for the user. Refer to the following sections of this procedure.

Adjustable Angle Flip-up Footplate Depth Adjustment (FIGURE 7)

2.Move the adjustable angle flip-up footplate to one

(1) of four (4) mounting positions.

3.Retighten the two (2) flat bolts, washers and lock- nuts.

NOTE: The settings for positioning the adjustable angle flip-up footplates on the half-clamps may vary for each footplate.

Adjustable Angle Flip-up Footplate Angle Adjustment (FIGURES 7 AND 8)

1.Loosen, but do not remove the two (2) flat bolts and locknuts that secure the adjustable angle flip-up footplate to the footplate hinge.

2.Position the adjustable angle flip-up footplate to the necessary angle to accommodate the user.

3.Retighten the two (2) flat bolts and locknuts.

Adjustable	Looking From
Angle Flip-up	Inside Towards
Footplate	the Outside of the
	Wheelchair.
	Footplate Hinge

FIGURE 8 - ADJUSTABLE ANGLE FLIP-UP

FOOTPLATE ANGLE ADJUSTMENT

1.Remove the two (2) flat bolts, washers and locknuts that secure the adjustable angle flip-up footplate to the footplate hinge.

NOTE: Observe the angle of the articulating footplate for reinstallation.

90o Footrest Support		Footplate Hinge
Flat Bolts
Adjustable		Nylon
Angle Flip-Up
Footplate		Adjustment
		Screw
Half
Clamp
Washers	Half
	Clamp
Locknuts		Footplate Hinge

FIGURE 7 - INSTALLING ADJUSTABLE ANGLE

FLIP-UP FOOTPLATES

Adjustable Angle Flip-up Footplate Perpendicular and/or Inversion/Eversion Adjustment (FIGURES 7 AND 9)

NOTE: It is not necessary to remove the footplate to perform this adjustment.

1.Insert a flathead screwdriver through the half clamp on the adjustable angle flip-up footplate.

2.Slowly turn the nylon adjustment screw in or out until the adjustable angle flip-up footplate is per- pendicular to the footrest assembly or the desired inversion/eversion is obtained.

Adjustable	Looking From the Front
Angle Flip-Up	Towards the Rear of
Footplate	the Wheelchair

Half Clamp

FIGURE 9 - ADJUSTABLE ANGLE FLIP-UP FOOTPLATE PERPENDICULAR AND/OR INVERSION/EVERSION ADJUSTMENT

18