FRONT RIGGINGS | PROCEDURE 1 |
REPLACING SECTOR BLOCK (FIGURE 10)
1.Remove the hex screw and washer that secure the existing sector block to the wheelchair frame.
2.Position the new sector block on the wheelchair frame. Make sure the locking pin is facing UP.
3.Secure the new sector block to the wheelchair frame with the existing hex screw and washer.
| Hex Screw | |
Wheelchair | Washer | |
Frame | ||
|
Sector Block
Locking Pin 
FIGURE 10 - REPLACING SECTOR BLOCK
OPTIONAL FOOTREST ACCESSORIES
Impact Guards/Calf Strap/H-Calf Strap (FIGURE 11)
NOTE: Impact Guards are Standard Equipment on Model ST Footrests. No assembly is required.
1.Remove impact guard/calf strap from packaged con- tainer.
2.Secure the impact guards to the footrest frame.
3.Secure the calf strap around the footrest frame (with the impact guards attached).
Impact Guard |
|
3.Remove the phillips bolt and locknut that secure the heel loop to the footplate.
4.Slide heel loop over the pivot tube.
5.Replace heel loop.
6.Reverse STEPS
NOTE: When securing the heel loop to the footrest assembly, tighten the phillips bolt and locknut until the spacer is secure.
Footrest
Hex Screw/Support
Coved Washer
Heel Loop
Phillips Bolt
Pivot Tube
Spacer 
Footplate
Locknut 
FIGURE 12 - REPLACING HEEL LOOPS - ALUMINUM OR COMPOSITE FOOTPLATES
FLIP-UP FOOTPLATES (FIGURE 13).
1.Remove the four (4) phillips screws and washers that secure the heel loop to the footplate.
2.Remove the existing heel loop from the footplate.
3.Position the new heel loop UNDER the footplate.
NOTE: If the heel loop is equipped with an ankle strap, position the heel loop on TOP of the footplate.
4.Line up mounting holes in footplate and heel loop.
5.Secure the new heel loop to the footplate with the four (4) existing phillips screws and washers.
Footplate
Heel Loop
F
R O N T
R
I
G G I N G S
Calf Strap
FIGURE 11 - IMPACT GUARDS/CALF STRAP/
H-CALF STRAP
Replacing Heel Loops
ALUMINUM OR COMPOSITE FOOTPLATES (FIGURE 12).
1.Remove the hex screw and coved washer that se- cure the pivot tube and footplate to footrest support.
2.Remove the pivot tube and footplate from the foot- rest support.
Phillips Screws
Washers
Phillips Screws
Washers
Heel Loop with
Ankle Strap
Footplate
FIGURE 13 - REPLACING HEEL LOOPS -
FLIP-UP FOOTPLATES
19
