ARMS

PROCEDURE 2

Removing

1.Press in on the locking lever and lift the "T" arm straight up and out of the "T" arm socket.

NOTE: If the "T" arm does not slide up and down in the "T" arm socket as desired, adjust the "T" arm socket. Refer to ADJUSTING THE "T" ARMS in this section of the manual.

2.Repeat STEP 2 for the opposite side of the wheel- chair.

"T" Arm

Wheelchair

 

Frame

Locking Lever

 

 

(Towards the

"T" Arm

front of the

wheelchair.)

Socket

 

 

Slot

FIGURE 2 - INSTALLING/REMOVING THE "T"

ARMS

ADJUSTING THE "T" ARMS

Height (FIGURE 3)

1.Unlock the "T" arm by flipping the "T" arm release lever towards the inside of the wheelchair.

NOTE: If necessary, Pull out on the "T" arm re- lease lever and rotate 180o so it can be flipped towards the outside of the wheelchair.

2.Slide the "T" arm to one (1) of:

A.Low Height "T" Arms - Nine (9) positions.

B.High Height "T" Arms - Seven (7) positions.

NOTE: If the inside "T" arm post does not slide up and down in the outside "T" arm post as desired, perform one (1) of the following:

A.Tighten - Tightening the set screws on the out- side "T" arm post will make it harder to move the inside "T" arm post up and down.

B.Loosen - Loosening the set screws on the out- side "T" arm post will make it easier to move the inside "T" arm post up and down.

3.Lock the "T" arm by flipping the "T" arm release lever towards the front of the wheelchair.

"T" Arm Release

Lever - Unlocked

Position

Inside "T"

Set

Arm Post

Screws

Outside "T"

Arm Post

"T" Arm Release Lever -

Locked Position

FIGURE 3 - ADJUSTING THE "T" ARMS -

HEIGHT

Width (FIGURE 4)

1.Remove the two (2) phillips screws that secure the arm pad to the arm tube.

2.Turn the arm pad around and reposition the arm pad on the arm tube.

3.Re-secure the arm pad to the arm tube with the two

(2) phillips screws.

4.Repeat for the opposite side, if necessary.

Arm Pad

 

Arm Tube

Phillips

Phillips Screw

Screw

 

FIGURE 4 - ADJUSTING THE "T" ARMS -

WIDTH

Depth (FIGURE 5)

1.Remove the two (2) phillips screws that secure the arm pad to the arm tube.

2.Remove the two (2) socket screws that secure the arm tube to the "T" arm post.

A R M S

21

Page 21
Image 21
Invacare 1061057, 96-100 manual Adjusting the T Arms, Removing, Height Figure, Width Figure, Depth Figure