106 Ion Operations Manual
Setup. The default is 30. When any other encoder is moved one revolution, the parameter will
change by the set percentage of its entire range. The default is 35.
The settings for {Encoder Degrees Per Revolution} and {Encoder Percent Per Revolution} are
stored with the showfile. Starting a new file will reset the two settings. Whether or not acceleration
is disabled or enabled is not stored with the showfile.
{Face Panel Keypad}
Auto Repeat
This setting allows you to adjust the auto repeat settings (delay and speed) for the facepanel
keypad.
Blackout
You can disable the [Blackout] hardkey here. By default, blackout is “Enabled”.
Grandmaster
You can disable the Grandmaster. By default the Grandmaster is “Enabled”.
Spacebar [Go]
You can enable the spacebar on an external keyboard as the hotkey for [Go]. By default, it is
“Disabled”.
Hide Mouse
With hide mouse enabled, if the mouse is left idle for 10 seconds, the cursor will go away. Once the
mouse is used again, the cursor will return. By default, this is “Disabled”.
Note:
If you turn acceleration off and move the encoder quickly, and you see movement
of the associated parameter slightly greater than indicated by your encoder
settings, a firmware update may be required for your Ion's encoders. See
“Firmware Update” on page349.